Anti-Slip

Variety of anti-slip aggregate & beading for use with Antel's epoxy coatings.

More details

New product

£ 10.00

- +

 
More info

Non Slip Aggregates

Non Slip Aggregates are available in three grades:-

FINE
MEDIUM
COARSE

The choice of grade is determined by the use for the finished surface.

APPLICATION

Non slip aggregates are applied in the same way for all systems.
Firstly a single application of the coating is applied to a carefully prepared surface. While this is still wet and active the non-slip aggregate is ‘broadcast’ evenly over the surface.

Do not over apply the aggregate as this is counter productive and will leave a surface which is very difficult to clean.

Allow the first coat to become tack free. Use a vacuum cleaner to remove any excess aggregate that has not adhered to the first coat.
Apply a further coat to the vacuumed area in order to lock in the non slip aggregate. A third coat may be required if the cover over the first coat and aggregate leaves a too harsh surface.

NOTE

Preparation is of vital importance. Lighter application result in optimum performance.


Clear Anti-Slip Bead

Clear Anti-Slip Bead can be mixed into an epoxy coating prior to application.  1 sachet will usually be enough for approximately 1 litre of material, but this varies depending on the viscosity of the coating so please check with our technical support before ordering.

Write a review

Anti-Slip
Variety of anti-slip aggregate & beading for use with Antel's epoxy coatings.

Write a review

 
Comments(0)

No customer reviews for the moment.

29 other products in the same category:

Customers who bought this product also bought:

No products

To be determined Shipping
£ 0.00 Total

Prices are tax excluded

Check out