Left Continue shopping
Your Order

You have no items in your cart

Perfecting Chemicals for the Building & Leisure Industries | Free Technical Advice - Tel: 023 9285 6110

Epoxy Grout Aggregate Filled

£43.78
Shipping calculated at checkout.

Grout Aggregate is a high quality, user friendly, ready mixed grout adhesive which can be used in grouting ceramic tile, brick and stone. It can be used for bonding ceramic tiles on concrete floors and is suitable for wide joints.


--

Epoxy Grout Aggregate Filled Technical Data Sheet

1. DESCRIPTION

Antel Epoxy Aggregate Filled Grout is a sand filled, pourable, self levelling grout. A three component, high strength epoxy resin system. Due to its high resistance to vibration, impact and shock its formulation makes it ideal for use in the installation of high strength anchors, support of base plates or any civil or mechanical engineering situations involving high dynamic loads, eg tie bars, bearing pads etc.

2. USES

- Civil engineering or structural grout
- Vibrating resistance
- Impact resistance
- Timber repairs

3. PACKAGING

A Three part product, packs marked A B & C which when mixed together give 1 litre, 2.5 litre, and 5 litre.

4. INSTRUCTIONS FOR USE.

4.1 Preparation:
Concrete surfaces should be clean and free from all loose material. All steel and machine beds should be free from grease and loose rust. In most cases Antel Aggregate Filled Grout does not require a primer.

4.2 Mixing:
Mix the entire contents of pack ‘B’ with pack ‘A’ stirring for three minutes. Slowly add the blended aggregate to the binder in the bucket and mix until uniform.

4.3 Application:
Once mixed the product can be poured into the hole, bed plate etc. allowing for a slight excess at the upper perimeter of the hole or shuttering around the bed plate.

4.4 Cure schedule:
Pot life @ 20°C 30 minutes
Full cure @ 20°C 7 days

5. COMPRESSION/TENSILE STRENGTH AT 20m C

After 4 hours: 26N/mm²
After 24 hours: 82.5N/mm²
After 7 days: 83.5N/mm²
Tensile strength:
After 7 days: 14N/mm²
Tensile bond to steel:
After 7 days: 12N/mm²
Shear bond to steel:
After 7 days: 18N/mm²

When fully cured the adhesion to concrete exceeds the tensile strength of the concrete.

6. LINEAR SHRINKAGE

0.009%

7. SHELF LIFE

12 months in original containers.

8. TOOL CLEANING

All tools etc should be cleaned with Antel Cleaning Solvent immediately after use.

9. CREEP

Provided that the in service temperature is no higher than 55°C creep will be negligible, even when subjected to a constant load as high as 40N/mm².