Silicone Sealant High Modulus

New product

Volume discounts

Quantity Price You Save
2 £ 67.80 Up to £ 6.78
3 £ 67.80 Up to £ 16.27
5 £ 67.80 Up to £ 33.90
8 £ 67.80 Up to £ 65.09

£ 67.80

- +

 
More info

Silicone Sealant High Modulus Technical Data Sheet

1. DESCRIPTION

Antel High Modulus Silicone Sealant is a one part flexible acetoxy silicone based sealant.

2. USES

Can be used for a wide range of applications including all joints, both interior and exterior, in the building industry. Universal bonding and sealing in the glazing industry, i.e. show cases etc.

3. PACKAGING

310 ml plastic cartridge complete with nozzle. Packaged 12 per box.

4. COLOUR

White - Clear - Black - Grey - Brown

5. STORAGE/SHELF LIFE

Store in cool, dry conditions. Protect from freezing.
Keep out of reach of children.
Shelf life - 12 months from date of shipment when stored below 32 ° C. Previously opened cartridges may be used by simply removing the cured plug of sealant from the top of the nozzle.

6. HEALTH & SAFETY

On contact, uncured silicone will irritate the eyes. In case of contact, remove the sealant and flush eyes thoroughly with water. If irritation persists seek medical attention. Avoid prolonged or repeated skin contact. Until fully cured silicone releases acetic acid. Ensure adequate ventilation during application. KEEP OUT OF REACH OF CHILDREN.

7. APPLICATION

All surfaces must be dry, clean and free from grease before applying the silicone. Some surfaces may require priming. Adhesion tests are recommended to determine necessity.

8. TYPICAL PROPERTIES

The following values are not intended for use in preparing specifications.
Remains permanently elastic after curing.
Does not shrink.
Keeps its colour and is waterproof.
Resists most chemicals and solvents.
Is non toxic after curing.
Has very good adhesion to glass and all commonly used building materials.
Resists temperatures ranging from -60° to +200°C
Skinning at +20°C and
65% RH 8/9 minutes
Curing at +20°C and
65% RH 1.5 mm per 24 hours
Hardness Shore A 20
Elongation at break -% Min 500% DIN 53504
Breaking Strength 1.6N/mm² DIN 53504
E-Modulus 100% 0.34N/mm²DIN 53504
P
Permeable to water vapour 2.8 G/M² per 24 hours
(10 mm joint thickness)
Processing Temperature +1°C to +30°C

Write a review

Silicone Sealant High Modulus

Write a review

 
Comments(0)

No customer reviews for the moment.

 
Custom tab

This is a custom block edited from admin panel.You can insert any content here.

3 other products in the same category:

No products

To be determined Shipping
£ 0.00 Total

Prices are tax excluded

Check out