Fast Set Epoxy Primer
|8||£ 15.17||Up to £ 16.55|
|5||£ 15.52||Up to £ 8.62|
|3||£ 15.86||Up to £ 4.14|
|2||£ 16.38||Up to £ 1.72|
Antel Epoxy Primer Solvent Free Fast Set is a low viscosity, two part Epoxy Resin, formulated to provide a material possessing outstanding adhesive qualities. It should be particularly used where Antel Epoxy self levelling flooring screed is being applied.
• Priming surfaces prior to the application of Antel Epoxy Floor Screed, Antel Epoxy self levelling floor screed and Antel Patching Mortar.
• Sealing and filling hairline cracks in concrete floors and structures.
• Bonding together broken concrete structures.
• Bonding asbestos cement to itself to wood or to concrete.
500ml, 1, 2.5 and 5 Litre sizes available.
4. USAGE RATE
3 – 6 m² per litre dependent upon porosity etc.
6. HEALTH & SAFETY
As Epoxy based products can be an irritant to the skin, all users are recommended to use a barrier cream and thoroughly wash with soap and water after use.
7. INSTRUCTIONS FOR USE
Surfaces must be dry and free from all foreign matter such as dust, grease, and dirt etc. Weak laitance and loose or flaking paint must be removed by wire brushing. Cleaning is imperative and best results can be obtained by using the appropriate Antel cleaner.
Empty the entire contents of Pack 'B' into Pack 'A' and mix thoroughly. Mixing should be carried out by a slow speed mechanical stirrer, or by hand using a flat bar paint mixer. Stirring should continue until a complete mix is achieved.
As a primer for Antel Epoxy Screed and Patching Mortar use as follows:-
Apply by brush immediately after mixing, working well into the surface and taking care not to form pools. Do not prime an area larger than can be dealt with in two hours. Should the primer be allowed to harden, a fresh application must be carried out before the appropriate mortar is applied. It may be necessary, when priming extremely porous surfaces, to apply a second coat after the first coat has become touch dry.
As a primer for Antel Epoxy self Smoothing floor screed
Apply by brush immediately after mixing, working well into the surface and taking care not to form pools. It may be necessary, when priming extremely porous surfaces, to apply a second coat after the first coat has become touch dry. This is especially true when applying Epoxy Self Smoothing Floor Screeds. Antel Epoxy self Smoothing floor screed should be applied when the primer is touch dry.
As a general adhesive use as follows:-
Apply by brush immediately after mixing. Materials to be bonded should be held firmly until the adhesive has hardened - approximately between 4 - 6 hours, dependent upon the temperature.
Pot life 12 -15 minutes
Application thickness 200-225 µm per coat
Initial cure 4-6 hours
Pedestrian traffic 16 hours
Heavy traffic 24 hours
7.5 Cleaning Tools:
Wash tools immediately after use with Antel Cleaning Solvent.