Contact Adhesive View larger

Contact Adhesive

New

High strength adhesive with excellent bond strength. For use with plastics, metals, leather, rubber urethane foams and other surfaces.

More details

£ 32.35

Volume discounts

Quantity Price You Save
8 £ 28.47 Up to £ 31.06
5 £ 29.12 Up to £ 16.18
3 £ 29.76 Up to £ 7.76
2 £ 30.73 Up to £ 3.24

Contact Adhesive Technical Data Sheet


1. DESCRIPTION

Antel Contact Adhesive is a brushable, general purpose, high performance contact adhesive. It exhibits excellent adhesion to most surfaces and has good heat resistance. Bonds may be made over a wide range of open times because of its fast flash off and long open time.

2. USES

Particularly recommended for bonding decorative laminates to wood and wood composites in the kitchen furniture industry.
It is also suitable for generally bonding :-
Plastics (not expanded polystyrene or plasticised PVC)
Metals
Leather
Rubber
Urethane Foams

3. PACKAGING

1 litre and 5 litre non returnable containers.

4. STORAGE

Highly flammable. Store at temperatures between -18°C and 0°C in original containers.
Keep out of reach of children.

5. COLOUR

Cream

6. COVERAGE/SHELF LIFE

3.5 +/- 1 metre square per litre.
12 months

7. HEALTH & SAFETY

Antel Contact Adhesive is HIGHLY FLAMMABLE. It is harmful by inhalation and irritating to the respiratory tract. Exposure may result in dizziness and loss of coordination. If in contact with the eyes flush with water for at least 15 minutes and obtain medical attention urgently. Prolonged or repeated contact with the skin can cause severe irritation. Wash contaminated skin immediately. Harmful if taken internally - seek medical attention immediately. DO NOT INDUCE VOMITING. Keep containers tightly closed when not in use.
Keep out of reach of children.

8. PHYSICAL DATA

Base Polychloropene
Viscosity 3400+/- 1000 cP
Solids 26+/-2%
Flash Point Between -18oC and 0oC
Tack Life 5-30 minutes

9. APPLICATION
Stir the Antel Contact Adhesive before use and ensure that the surfaces to be bonded are clean and free from grease, dust loose fibres, rust etc. Condition materials to be bonded in the bonding environment overnight (especially wood composites and decorative laminates).
Apply a thin even coat of adhesive to both surfaces using a short stiff brush. When surfaces become touch dry align the bond edges and bond under maximum pressure. For best results laminates should be nip rolled or platen pressed. If this is not possible use a hard roller and go over the entire working surface using as much bodyweight as possible. Seams and edges should always receive extra pressure. If possible sandwich the panel edge between wooden battens and use G-clamps.
The newly bonded material should not be subjected to extreme temperature changes for three to four days after bonding and avoid further fabrication until the adhesive has fully cured.

7 other products

Special Offers

Viewed products

PayPal